BIGTREETECH 3D Printer Part SKR V1.4 Turbo 32bit Control Board Smoothieboard&Marlin Open Source SKR V1.4 SKR V1.3 Upgrade Support TMC2209/TMC2208/TMC2130 Drivers (SKR V1.4 Turbo)

Package Included
1pc SKR V1.4 Turbo Board
1PC USB Cable

Product Features

  • Using 32bit main frequency 120MHz ARM level Cortex-M3 series LPC1769 Microprocessor
  • I2C, SPI and WIFI interfaces are reserved for convenience of DIY
  • Double z-axis interface, eliminating the trouble of external drive expansion Module
  • More fan interfaces: 1 way CNC fan, 3 way normally open fan
  • Plug-in external DC5V power supply module to supply power to TFT screen, BLtouch and Neopixel

Visit The Website For More Information…

3 thoughts on “BIGTREETECH 3D Printer Part SKR V1.4 Turbo 32bit Control Board Smoothieboard&Marlin Open Source SKR V1.4 SKR V1.3 Upgrade Support TMC2209/TMC2208/TMC2130 Drivers (SKR V1.4 Turbo)”

  1. So far so good 5-13-2019 updateI just finished installing some of the TMC2310 SPI stepper drivers with this board and Klipper. Now I need new fans! It is so quiet. Setup was simple as the drivers came setup to run in SPI mode. All the configuration was done in Klipper with very little problems. All problems encountered were because I did not read the instructions!!! Set the current on my steppers to .6 for X Y and Z and the extruder was set to .5 amps. Have not set up the stall guard yet to use them…

  2. This is definitely an advanced project I should have done this upgrade sooner. It is well worth the time and trouble. But I would put this more on the advanced end of the upgrade spectrum. The board is fantastic and the TMC2130 servo drivers are EXTREMELY quiet. I did this upgrade as I have an Ender 3 and the stock control board has locked, loud drivers, no memory left over for firmware changes (to add upgrades), and it doesn’t have a boat loader included for doing firmware flashes (so you have to spend money for another board…

  3. What a joke of product and support. Be aware and look else where!!! Doesn’t work always. Doesn’t boot up. The board gets power and the so does the LCD screen but the board won’t respond to anything. Like the CPU is dead. Tried multiple firmware and even 2different PSU same issue. Contacted seller and what a joke they are we went back and forward via messages and they at the end said to contact Amazon. No help no knowledge of there product. Honestly it’s a bigtreetech skr board so the best way to get one and have the best experience would be to buy it directly…

Leave a Reply

Your email address will not be published. Required fields are marked *